SMOK TFV8 RBA Coil - Coil rigenerabile per Smok TFV8
Attenzione: Ultimi articoli in magazzino!
(Compatibile con atomizzatore SMOK TFV8)
SMOK TFV8 RBA Coil, is the special Coil base for SMOK TFV8 tank, master DIY piece for TFV8 RBA vaping!
It comes with
1. 18mm large deck, suitable for all types of material wire, brings you unique vaping experience
2. Turbo: 4.0T-X
3. Pre-installed: Patented Fused
4. Clapton Dual Coils 0.28Ω (50W-140W)
How to replace the coil unit/coil head
How to build the RBA:
1. before, please make sure your hands are clean;
2. take RBA apart;
3. install and position the pre-wrapped coil: place the coil between the posts and wrap the ends around the screws and tighten up, make sure the coil is fined in the center and lined up with the air hole and also make sure the coil is not touching the base;
4. cutting the ends of wire off;
5. cut a strip of cotton and make sure it's not too much or too less;
6. insert the cotton, and placing it in the middle;
7. cutting the cotton at an angle and make sure it's not too short or too long.
8. wet the coil with your liquid and adjust the cotton.
Ancora nessuna recensione da parte degli utenti.